Flex OBD Connection for Ford UTCU3

Fomoco UTCU3 TCUs Now Covered

New version 7.47.0.0 of Flex out now, introducing a new protocol dedicated to Fomoco UTCU3 TCUs installed on Ford vehicles with 6, 8, and 10-speed automatic transmissions.

 

With the new Flex release, you can perform OBD programming of a wide range of vehicles that are equipped with this control unit, by connecting directly to the diagnostic port.

 

Operating in OBD means getting quick access to the map area, making it possible to carry out necessary modifications to optimize transmission performance.

Some of the supported vehicles

Check all supported vehicles

• Ford Bronco (VI) (2020MY) 2.7L Ecoboost V6 335PS

• Ford Kuga (III) (2020MY) 1.5L EcoBoost 150PS

• Ford Ranger T6 (2019MY) 2.3L Ecoboost 270PS

New protocol available for the following software packages:

OBD

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master

• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave

• FLS0.5M – SW Flex Full Master

• FLS0.5S – SW Flex Full Slave

Buy Software

Newly added protocols:

OBD

• Ford Fomoco UTCU3 TC277 Read/Write/Checksum Calculation Maps

Writing Time

~15 minutes

Reading Time

~10 minutes