Flex OBD and Boot for Ducati Continental M3D

Flex for Ducati Continental M3D

OBD and Boot Modes Now Supported

New Flex release, version 7.55.0.0, dedicated to Ducati vehicles with Continental M3D ECUs. Program via OBD using the 4-pin MMS03.003 cable for Euro 4 models, or use Boot mode for full ECU access and backup.

Supported Vehicles

Check all supported vehicles

• Ducati Hypermotard 950 (I) 937cc (E4) 113HP (2019MY)
• Ducati SuperSport 939 (I) 937cc (E4) 111HP (2017MY)
• Ducati Monster 1200 (II) 1198cc (E4) 148HP (2017MY)
• Ducati Scrambler 1100 (I) 1079cc (E4) 85HP (2017MY)

This new protocol is available for the following software packages:

OBD / BOOT

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
• FLS0.5M – SW Flex Full Master
• FLS0.5S – SW Flex Full Slave
• FLS0.13M – SW Flex Bikes OBD/Bench/Boot Master
• FLS0.13S – SW Flex Bikes OBD/Bench/Boot Slave

Buy Software

Newly added protocols:

OBD

• Ducati Continental M3D MPC5534 Read/Write/Checksum Calculation Maps

BOOT

• Ducati Continental M3D MPC5534 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Full Backup

Bug Fixes:

• Various bug fixes and improvements