Flex in OBD for IVECO MD1CS069

Iveco Bosch MD1CS069 Now Ready

New Flex update, version 7.49.0.0, now available, implementing OBD programming for the most modern Iveco vehicles equipped with Bosch MD1CS069, even those produced after 2021.

 

Thanks to this new protocol, you can now work directly from the diagnostic port of the vehicle (bypassing the SGW module), or establishing direct connection through the connector.

 

As of today, working on the map area doesn’t require unlocking the control unit nor shipping it to us: remove DTCs, boost engine performance, or cut consumption, all in a few minutes.

Some of the supported vehicles

Check all supported vehicles

• Iveco Daily (IV) 2.3L FPT 16v 134HP

• Iveco Daily (IV) 3.0L FTP 16v 177HP

New protocol available for the following software packages:

OBD

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master

• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave

• FLS0.5M – SW Flex Full Master

• FLS0.5S – SW Flex Full Slave  

Buy Software

Newly added protocols:

OBD

• Iveco Bosch MD1CS069 TC299 Read/Write/Checksum Calculation Maps

Writing Time

~2 minutes

Reading Time

~5 minutes