Flex Bench Support for VAG Bosch DQ500 Gen2, DQ38x, and ZF AL552

Bench for VAG DQ500 Gen2, DQ38x, and ZF AL552

VAG Automatic TCUs in Bench

Version 7.52.0.0 of Flex introduces Bench mode for Bosch DQ500 Gen2 automatic transmission control units, common on the latest VAG vehicles. Support is extended to Bosch DQ38x (2022+) and ZF AL552 Gen2 (2022+). ECU cloning is supported when the Bosch Part Number matches.

Supported Vehicles

Check all supported vehicles

• Audi RS6 (C8) 4.0 V8 Twin-Turbo 600PS
• Cupra Formentor (II) 2.0L TSI 250PS
• Lamborghini Urus (I) 4.0L TFSI 650PS
• Porsche Cayenne (III) 3.0L Turbo S 330PS
• Skoda Octavia (IV) 1.5L TSI 150PS
• Volkswagen Golf (VIII) 2.0L GTI Performance 250PS

This new protocol is available for the following software packages:

BENCH

• FLS0.2M – SW Flex TCU OBD/Bench/Boot (car, bike, van) Master
• FLS0.2S – SW Flex TCU OBD/Bench/Boot (car, bike, van) Slave
• FLS0.5M – SW Flex Full Master
• FLS0.5S – SW Flex Full Slave

Buy Software

Newly added protocols:

BENCH

• VAG Bosch DQ500 Gen2 (2022+) Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM, Full Backup
• VAG Bosch DQ38x Gen2 (2022+) Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM, Full Backup
• VAG ZF AL552 Gen2 (2022+) Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM, Full Backup

Bug Fixes:

• Various bug fixes and improvements