Flex Bench for Marelli 11GF

Solution for Marelli 11GF Units

New release out now for Marelli 11GF control units.

 

This Flex update, version 7.48.0.0, allows you to Bench program FCA engine control units equipped on mild hybrid systems, extending intervention possibilities on a more modern range of vehicles.

 

With protocol for Marelli 11GF you can perform engine calibration operations in order to improve performance, as well as restore and clone ECUs without the need to open the unit.

 

It’s super easy: read the full backup of the damaged unit and transfer data to a working unit. No need to have both vehicles inside the workshop.

Some of the supported vehicles

Check all supported vehicles

• Fiat 500 (332) 1.0L FireFly MHEV 68HP

• Fiat Panda (312) 1.0L FireFly MHEV 68HP

• Lancia Ypsilon (846) 1.0L FireFly MHEV 68HP

New protocol available for the following software packages:

BENCH

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master

• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave

• FLS0.5M – SW Flex Full Master

• FLS0.5S – SW Flex Full Slave

• FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master

• FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave

Buy Software

Newly added protocols:

BENCH

• FCA Marelli 11GF TC277 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Read/Write External EEPROM, Full Backup

Writing Time

~1 minute and 30 seconds

Reading Time

~2 minutes

Bug fixes:

• Added support for some new versions of SID213 and EMS29xx

Software improvements:

• Reading and Writing function in SID213 and EMS29xx have been speeded up