Flex Bench and Boot Support for DAF Cummins CM1880/CM1881

Flex Bench and Boot Support for DAF Cummins CM1880/CM1881

Flex version 7.36.0.0 is ready

Supported Vehicles

Check all supported vehicles

• DongFeng Tianjin 4.7L 180PS
• DAF XF 106 (II) 10.8L 340PS
• DAF XF 105 12.9L 510PS

This new protocol is available for the following software packages:

BENCH/BOOT

Bench

• FLS0.4M – SW Flex Boot Nexus MPC5xxx Master
• FLS0.4S – SW Flex Boot Nexus MPC5xxx Slave
• FLS0.5M – SW Flex Full Master
• FLS0.5S – SW Flex Full Slave
• FLS0.15M – SW Flex Heavy Duty OBD/Bench/Boot Master
• FLS0.15S – SW Flex Heavy Duty OBD/Bench/Boot Slave

Boot

• FLS0.5M – SW Flex Full Master
• FLS0.5S – SW Flex Full Slave
• FLS0.15M – SW Flex Heavy Duty OBD/Bench/Boot Master
• FLS0.15S – SW Flex Heavy Duty OBD/Bench/Boot Slave

Buy Software

Newly added protocols:

BENCH

• DongFeng Cummins CM1880 SPC546A – Read/Write/Checksum Calculation Internal Flash
• DAF Cummins CM1881 SPC546A – Read/Write/Checksum Calculation Internal Flash

Reading Time: ~ 8 minutes  Writing Time: ~ 5 minutes

BOOT

• DongFeng Cummins CM1880 SPC546A – Read/Write/Checksum Calculation Internal Flash
• DAF Cummins CM1881 SPC546A – Read/Write/Checksum Calculation Internal Flash

Reading Time: ~ 1 minute  Writing Time: ~ 50 seconds

Bug Fixes:

• Software improvements
• Added Isuzu Transtron M5.2.1 in OBD and Bench mode