BMW & Mini MDG1: Keep it closed. Work in Bench 

Version 8.12.0.0 of Flex Out Now

The new Flex update introduces a world exclusive: a solution for last generation Bosch MDG1 control units installed on BMW & Mini vehicles.

Connect it. Then work in Bench!

This new protocol allows you to work directly via pinout, no need to operate in Boot Glitch mode, which means no need to open the unit to perform the unlock.

An exclusive solution to make the programming process easier, faster, and safer, optimizing your workflow and reducing working time.

Less steps.

Less risks.

Shorter working time.

This new protocol is available for:

• BMW Bosch MD1CP032 TC299

• BMW Bosch MD1CS001 TC298

• BMW Bosch MG1CS024 TC299

• BMW Bosch MG1CS049 TC298

• BMW Bosch MG1CS201 TC298

Key insights

Buy Flex

• Working Mode: Bench

• Memories: Read/Write/Checksum Internal Flash, Read/Write Internal EEPROM, Full Backup

• License: FLS0.1M/S – FLS0.10M/S – FLS0.5M/S

• Connection: ~10 seconds

• Reading Time: ~2 minutes 30 seconds

• Writing Time: ~2 minutes

Some of the supported vehicles

Check all supported vehicles

•  BMW 4-Series Gran Coupe (I) G26 (2021MY) 2.0L 420d MHEV 187HP

• BMW M2-Series (II) G87 (2023MY) 3.0L Twin-Turbo 24v 453HP

• BMW M4-Series (II) G82 (2021MY) 3.0L Twin-Turbo 24v 542HP

• BMW X2-Series (II) U10 (2023MY) 2.0L 20d sDrive/xDrive MHEV 161HP

• Mini Cooper (F57) (2020MY) 1.5L 139HP

Changelog

• Fixed OBDFull connection problem on some DQ500 HWs

• Implemented CRC on newer MDG1